Netgate SG-1000 microFirewall

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - faldfjie

Pages: [1]
1
General Questions / Re: PPPoE
« on: February 08, 2018, 05:42:30 pm »
Thank you, Grimson.  I found my mistake. I failed to map the PPP setting to the correct interface.  In fairness, I thought the list of four interfaces (what the device I am using has), was all that was showing in the selection box...until I discovered there was one entry below the pick box (hidden)...which was the adapter with the VLAN tag bound to it.  For the longest time, I thought when I created the VLAN itself that the parent interface reference was sufficient to make things work...I was wrong.

Thanks again!

2
General Questions / PPPoE
« on: February 07, 2018, 11:39:28 pm »
Hi, I have been trying to get my PPPoE connection working for a couple hours (2.4.2) and am having no luck with it.  The configuration I have seems like it should work, but it isn't.

I am trying to connect to Century Links gig e service.  It comes encapsulated in VLAN 201.

What I did was install pfsense and went through the getting started wizard.

I configured the WAN port to PPPoe, and put in my username/password.

I then went to the Interface assignments page and created a VLAN ID 201 and assigned it to the WAN interface.  Under the PPP setting, I bound it to the physical interface connected to century link.

I also set the Dial on Demand and Time Outs per https://kdemaria.wordpress.com/2015/04/22/how-to-configure-pfsense-2-2-2-for-centurylink-gigabit-seattle-edition/

When I look at the PPP logs I get:

Feb 7 19:43:24   ppp                        [wan_link0] Link: reconnection attempt 65

Feb 7 19:43:24   ppp                        [wan_link0] PPPoE: can't connect "[14]:"->"mpd67494-0" and "[261]:"->"left": No such file or directory

Feb 7 19:43:24   ppp                        [wan_link0] can't remove hook mpd67494-0 from node "[14]:": No such file or directory

Feb 7 19:43:24   ppp                        [wan_link0] Link: DOWN event
Feb 7 19:43:24   ppp                        [wan_link0] LCP: Down event

I am wondering if I am overlooking something obvious.  It just seemed to me like you setup the WAN link for PPPoE go to Interface-->Assignment-->VLAN and create a tag you associate with the physical adapter the WAN connection is using and you should be cooking with gas.

Anyone have a clue?

Pages: [1]