Netgate SG-1000 microFirewall

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Inv1sion

Pages: [1]

Thanks for the info. I have search only last night and after a long many hours found my potential solution. I will have to test today. I will also be searching the virtualization forum also for alternatives.

General Questions / Issue creating vlan, no parent interface in list
« on: March 08, 2018, 12:56:38 pm »

I am new to the forum but have been using pfsense for a while now and I am looking to start adding vlans' to pfsense as I will be replacing all our existing networking equipment shortly and will be separating some of the equipment in place (computers, wireless, cameras, etc...) however I am running into an issue where I cannot add any vlans'.

When I try to add a vlan, I can enter in all the information however there are no interfaces that show up in the 'parent interface' drop down list.

I have tried searching this forum as well as other sources and have not had any luck in finding a solution. It is a basic setup and have only recently added snort but the issue was there prior to adding snort.

I am currently running version 2.3.4-release-p1. It is running in a VM on xenserver 7.1.



Pages: [1]