Netgate SG-1000 microFirewall

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - morph0

Pages: [1]
Wireless / Wifi to Lan Bridge problems
« on: September 07, 2009, 02:15:44 am »
Hi all, i have been reading different guides and been in mIRC asking for assistance but keep running into a wall.

I am trying to install a WiFi card into an existing pFsense box which is currently running the following,

Load Balanced
Wan1 (ADSL PPPoE Connection)
Wan2(opt1) (Cable DHCP Connection)

Lan (192.168.10.x)

DHCP is being handled by a 2k3 box and i have setup DHCP relay on pFsense to point to the 2k3 box.

I have installed the WiFi card and set it up under the webgui as WLAN1(opt2). I then setup the WiFi as an access point with no security just as a test. I then bridged wlan to lan and also I created rules under

Firewall | Nat Outbound |

WLAN1  *  *  *  *  *  YES

Firewall | Rules | Wlan1 |

UDP  *  68  67  *
UDP  *  68  67  *
*  *  *  *  *  *
*  LAN net  *  *  *  *
*  WLAN1 net  *  *  *  *

This has left me what i thought pretty safe to pass everything the WiFi card gets sent but i was wrong. DHCP doesnt work on the wifi card on the laptop or the iphone and setting it to static only works half the time to reach the internet.

Any advice would be muchly appreciated.

Pages: [1]