Netgate SG-1000 microFirewall

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - shimano

Pages: [1]
Hello guys i have this problem with squid server, i have it setup without any cache option, antivirus is off, just a squid server for my vpn so i can use my home ip while on the go.

Squid works really great for a while, after it gets really slugish, like i have to wait 1-2 mint for a page to response ! everything gets back to normal after i reboot my pfsense and works great for a day or two then again i have really slow speeds so i have to reboot again.

What could cause this issue ?

i am running pfSense 2.4.2 on Firebox XTM 5 with Samsung PRO SSD 256GB, 2GB ram and CPU E7200 @ 2.53GHz.

2.4 Development Snapshots / Gateway monitor help
« on: January 31, 2018, 05:07:54 pm »
Hey guys, can anybody help me fix the gateway monitor widget ? i have a dynamic pppoe wan connection with ip changing all the time so is there any way to make the gateway widget work ?

Thank you !

Installation and Upgrades / cannot update from 2.3.4 nanobsd to 2.4.0
« on: January 26, 2018, 03:34:44 pm »
Hello guys,

I am new here to the forum, please help me out with this problem i have.

I've been using pfsense for more than a year been very very happy with ! i got a firebox XTM 5 firewall running pfsnese on a CF.

I got old fashion nanobsd of 4G using 2 slices and now i want to upgrade to 2.4.0 without loosing everything since i got a lot of stuff configured.

And i was following the guide to upgrade posted here:

and i got to this point it says:

     If Bootup Slice ends in s2 then the firewall is booting from the secondary slice and must be changed to boot from the first slice using the following steps

Click Duplicate XXXs2 -> XXXs1
Click Switch Slice to change the boot slice to XXXs1

Well by boot slice end is s2 its actually ada0s2 but when i went to Diagnostics / nanoBSD to copy ada0s2 into ada0s1 i only have a option to copy ada0s1 into ada0s2 !! and that is not good, i've attached a picture:

Also i've read in the guide that there is a option 2 for this namely:  # /bin/dd if=/dev/ada0s2 of=/dev/ada0s1 bs=64k

I have tried this also and got this error that i could not pass:

[2.3.4-RELEASE][root@pfSense.shimano.home]/: /bin/dd if=/dev/ada0s2 of=/dev/ada0s1 bs=64k
dd: /dev/ada0s1: Operation not permitted

so i cannot copy s2 into s1 so i change boot to s1 and continue with the installation, i have searched over the internet for the past month and could not do it...

please help me out with this as i am stuck and really to update to 2.4.0 and beyond.

Thank you very much all for your time and effort.


Pages: [1]