The pfSense Store

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Trel

Pages: 1 2 3 4 [5]
61
Installation and Upgrades / Can pfsense install to an ext3 partition
« on: September 24, 2013, 11:25:47 am »
If I were to partition a drive with ext3, could pfsense install to that, or is the BSD partition required?

62
Installation and Upgrades / Installation partition type
« on: June 25, 2013, 08:22:18 am »
Is it possible to install PFSense to a Linux formatted partition instead of a BSD one?  I know I can choose a linux partition as an option in the installer, but I wasn't sure if it was possible.

63
General Questions / I cannot get certificate to install
« on: June 15, 2013, 09:32:56 am »
Here's what I'm doing and have done.

-Fresh install
-Restored config from old install (same versions)
-Reboots as necessary

-Generate CSR
-Go to Geotrust RapidSSL (via namecheap)
-Input CSR (server: other)
-Receive email with cert
-Paste Cert into the field for it

And then I get
Quote
The following input errors were detected:

    The certificate modulus does not match the signing request modulus.

So I'm lost as to what to do.  I can't figure out what I'm doing wrong here.

64
My logs show a number of blocks like this


Date: May 10 11:05:51
Interface: WIFI01    
Source: 176.16.2.102:57020
Destination: <removed>:80  (non-lan)
Type: TCP:FA

It says the rule that's blocking it is the default block rule.

However, I have a rule in place which is to allow Any protocol, WIFI01 source, any destination, so I'm not sure how there could possible be an outbound block.

65
LAN and OPT1 are my interfaces.
I want to bridge them (and possibly later add OPT2).

What's the proper way to do this and have a DHCP server (which interface should it ideally run on)?

66
DHCP and DNS / How can I achieve this setup?
« on: May 07, 2013, 10:34:25 am »
I'm trying to do the following

IP: 176.16.x.x
Subnet: 255.255.252.0

I have two  interfaces, LAN and OPT1.
What I want to do is devices connecting on LAN (port 1 of a 4 port NIC) get 176.16.1.x and on OPT1 (single port NIC) get 176.16.2.x


What is the best way to achieve this?

67
Hardware / Wireless standard went missing
« on: May 06, 2013, 08:15:37 pm »
When I first set up pfsense, my wireless nic had three options for wireless standard.
-b
-g
-gn

When I look now, gn is missing from that list.
Anyone know what might have happened?

It's an Atheros nic, I'm certain of the exact model, but I do know it supports n.

Pages: 1 2 3 4 [5]