pfSense Gold Subscription

Author Topic: gitsync'd to 2.4 by mistake - going back?  (Read 1525 times)

0 Members and 1 Guest are viewing this topic.

Offline luckman212

  • Hero Member
  • *****
  • Posts: 726
  • Karma: +59/-0
    • View Profile
    • @luckman212 - github
gitsync'd to 2.4 by mistake - going back?
« on: May 13, 2016, 07:40:31 am »
I made a mistake this morning (do not operate firewalls before proper dosage of caffeine!) and issued the following from the dev shell

Code: [Select]
playback gitsync master
when I should have specified RELENG_2_3 as the branch. I wound up with something that said "2.4" on the dashboard which I didn't want. So I logged back in and ran

Code: [Select]
playback gitsync RELENG_2_3
which ran very quickly and didn't seem to change much but lo and behold my dash now says 2.3.1-DEVELOPMENT (amd64) again. Anything to worry about? Do I have a Frankenstein system now and if so is there any proper way to get back or do I need to pave over this? Seems to work ok  :P

Offline cmb

  • Hero Member
  • *****
  • Posts: 11230
  • Karma: +893/-7
    • View Profile
    • Chris Buechler
Re: gitsync'd to 2.4 by mistake - going back?
« Reply #1 on: May 13, 2016, 07:42:35 am »
It's fine at this point to gitsync back to RELENG_2_3.

Offline luckman212

  • Hero Member
  • *****
  • Posts: 726
  • Karma: +59/-0
    • View Profile
    • @luckman212 - github
Re: gitsync'd to 2.4 by mistake - going back?
« Reply #2 on: May 13, 2016, 12:34:24 pm »
Thanks again - seems to work!

"pfSense - The Friday the 13th Edition"    :o



Offline Perforado

  • Jr. Member
  • **
  • Posts: 60
  • Karma: +9/-0
    • View Profile
Re: gitsync'd to 2.4 by mistake - going back?
« Reply #3 on: May 14, 2016, 04:47:47 am »
Best one yet. Sadly no hockey mask included  ;D