Netgate SG-1000 microFirewall

Author Topic: VMWare appliance + Interfaces  (Read 1731 times)

0 Members and 1 Guest are viewing this topic.

Offline an0key

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
VMWare appliance + Interfaces
« on: November 29, 2008, 08:30:11 am »
Just downloaded the latest vm appliance, running on server 2x. Picks up the DHCP address on the WAN fine, however once I've run the initial setup process via the webgui, that interface just states

WAN > em0 > None.

It's the same if I use a static address or dhcp.

Is this a known fault? Have had a search around, can't see anything obvious...