Netgate SG-1000 microFirewall

Author Topic: CARP setup on load balancing network  (Read 218 times)

0 Members and 1 Guest are viewing this topic.

Offline timmerdanny

  • Newbie
  • *
  • Posts: 19
  • Karma: +0/-0
    • View Profile
CARP setup on load balancing network
« on: October 17, 2017, 01:03:33 pm »
Hi Pfsense members,

I am trying to setup a CARP with state synchronisation. I have two Pfsense Netgate SG-8860 1U boxes and want to have high availability on my network. Our ISP offers high availability. They have two uplinks with equal cost load balancing. So if a package send back out of R1 interface, it may get back on R2 WAN interface. I would like to have both boxes to share one WAN IP address, IPsec VPN should also be redundant.
I have tried to setup the envouriment, but my R2 does not seem to work. Can anybody tell me if my described scenario can work?

I have setup the following:
- Setup CARP interface, enable state synchronization (pfsync)
- Setup XMLRPC Sync
- SETUP CARP for LAN IP address
- Configured the same WAN IP address for both routers