Administrative > Messages from the pfSense Team

pfSense 2.3.5-RELEASE now available!

(1/2) > >>


According to the update instructions:

Upgrading to pfSense 2.3.5-RELEASE

Updating to pfSense 2.3.5 from pfSense 2.3.4 on an amd64 installation that could otherwise use pfSense 2.4.x requires configuring the firewall to stay on pfSense 2.3.x releases as follows:

    Navigate to System > Update, Update Settings tab
    Set Branch to Security / Errata Only
    Navigate back to the Update tab to see the latest pfSense 2.3.x update

The same change is required to see pfSense 2.3.x packages for users staying on pfSense 2.3.x.

If the update system offers an upgrade to pfSense 2.3.5 but the upgrade will not proceed, ensure that the firewall is set to the correct update branch as mentioned above. If the firewall is on the correct branch, refresh the repository configuration and upgrade script by running the following commands from the console or shell:

pkg install -fy pfSense-repo pfSense-upgrade

Firewalls running 32-bit (i386) installations of pfSense software do not need to take any special actions to remain on 2.3.x as they are unable to run later versions.

However, I'm not seeing Security / Errata Only as a choice.

Only development and stable. 

Wondering if I should run pkg install -fy pfSense-repo pfSense-upgrade anyway or do something else?

Thanks in advance.  I only have 1 32 bit system out there but it works very well, so its nice to keep it going a bit longer. 

To get it to show up, I switched to developement, saved it.  Checked for an update...

Then switched back to stable, saved it, checked for an update.  It saw the update then.  All good.

worked as documented on my pfsense.

Thanks for still supporting "the old version"

Looks like the nano images are missing?


[0] Message Index

[#] Next page

Go to full version