The pfSense Store

Author Topic: SNMP reporting incorrect (double?) the bandwidth usage  (Read 198 times)

0 Members and 1 Guest are viewing this topic.

Offline alex_london

  • Newbie
  • *
  • Posts: 16
  • Karma: +0/-0
    • View Profile
SNMP reporting incorrect (double?) the bandwidth usage
« on: November 01, 2017, 08:53:39 pm »
Hi,

I've just set up a new SG-3100, and using SNMP sensors in PRTG to monitor various statistics, including bandwidth. The reported bandwidth in PRTG seems to be double the actual use - I'm seeing 20Mbps where it should be closer to 10Mbps (I wish it was 20!).

I'm using a Multi-WAN setup, with policy-based routing, so I'm not doing anything fancy with load balancing etc. Both WAN links (WAN/mvneta2 and OPT1/mvneta0) seem to be exhibiting the same behaviour.

The RRD charts in the device itself seem to be correct.

Any thoughts?

Thanks,
-Alex

Offline loos

  • Global Moderator
  • Newbie
  • *****
  • Posts: 15
  • Karma: +7/-0
    • View Profile
Re: SNMP reporting incorrect (double?) the bandwidth usage
« Reply #1 on: November 02, 2017, 09:54:51 pm »
This issue was found after the release of 2.4.1 and it is already fixed for the 2.4.2.

Offline alex_london

  • Newbie
  • *
  • Posts: 16
  • Karma: +0/-0
    • View Profile
Re: SNMP reporting incorrect (double?) the bandwidth usage
« Reply #2 on: November 03, 2017, 05:40:35 am »
Ah, ok thanks! I'll await the update then...

-Alex