Netgate SG-1000 microFirewall

Author Topic: DHCP6 will not pull IPv6 address on WAN Interface  (Read 186 times)

0 Members and 1 Guest are viewing this topic.

Offline Pookie

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
DHCP6 will not pull IPv6 address on WAN Interface
« on: January 25, 2018, 02:38:31 am »
Hello,

I have been trying to configure my PFsense firewall to obtain an IPv4 and Ipv6 address on the WAN interface. I have the IPv4 address pulled on the WAN interface via DHCP. When I select DHCP6 to pull the IPv6 address for the WAN interface, it does not pull at all. I have looked at the logs but not sure what is exactly wrong. Below is what I continue to see in the logs for dhcp6. Current PFSense version is 2.4.2


dhcp6c[5469]: failed to open /usr/local/etc/dhcp6cctlkey: No such file or directory
dhcp6c[5469]: failed initialize control message authentication
dhcp6c[5469]: skip opening control port
dhcp6c[5469]: /var/etc/dhcp6c_wan.conf:3 IA_PD (0) is not defined
dhcp6c[5469]: failed to parse configuration file

Offline bimmerdriver

  • Sr. Member
  • ****
  • Posts: 515
  • Karma: +21/-3
    • View Profile
Re: DHCP6 will not pull IPv6 address on WAN Interface
« Reply #1 on: January 31, 2018, 07:17:55 pm »
Do you know what settings your isp requires? The edge router may not even provide an ip address for the wan. You must request a prefix size that is supported. The edge router may only support one size. It may require you to only request a prefix, not a prefix and an address. If your router isn't asking for a supported configuration, nothing will be delegated.