Netgate SG-1000 microFirewall

Author Topic: Pfsense IPsec webpages not working  (Read 84 times)

0 Members and 1 Guest are viewing this topic.

Offline timmerdanny

  • Newbie
  • *
  • Posts: 19
  • Karma: +0/-0
    • View Profile
Pfsense IPsec webpages not working
« on: January 31, 2018, 09:39:24 am »
We have a IPsec site to site VPN. The VPN is corretly setup and only allow all policies are applied on IPsec interface and LAN interface. From site 1 I can ping/SSH to 10.0.0.1 but I am not able to open the web configurator. The configurator runs at port 80 and I'm sure I have set the allow all on the LAN and IPsec. I'm trying to connect the webconfigurator by IP address.

Site 1
192.168.0.0/24
LAN gateway address: 192.168.0.1
Hardware: Mikrotik Router

Site 2
10.0.0.0/24
LAN gateway address: 10.0.0.1

VPN authentication: SHA512
Encryption Algorithm: AES256

I already tried to switch the web configurator port to port 81, but I am still not able to access the webpage.

Offline timmerdanny

  • Newbie
  • *
  • Posts: 19
  • Karma: +0/-0
    • View Profile
Re: Pfsense IPsec webpages not working
« Reply #1 on: January 31, 2018, 10:17:07 am »
Ok I think I found a solutions. Somehow my HTTP(s) got dropped when using SHA512/AES256 to the Mikrotik box. When I use SHA1 and AES128 http(s) requests works fine and I am able to access the webconfigurator. Spend a lot of time finding this out, because only http(s) connections got dropped somehow.