Netgate SG-1000 microFirewall

Author Topic: Installer doesn't see drives  (Read 2635 times)

0 Members and 1 Guest are viewing this topic.

Offline sbn

  • Newbie
  • *
  • Posts: 7
  • Karma: +0/-0
    • View Profile
Installer doesn't see drives
« on: November 29, 2005, 09:07:26 pm »
Just downloaded 0.95a.iso and 0.95ab.iso. I selected install to hard drive, install GUI comes up fine. But, it will not install as the installer does not see any drive. Upon boot though I do see the IDE drive identified. I swapped out drives and came up with the same issue. The drives are just standard ATA on a P-II (Compaq) desktop w/2 NICs and no other cards installed etc.. System has 512MB RAM, 2 3COM 905C cards.
 
I previously had installed 0.94.10 on the same machine on another drive that was pulled out for use in another machine. It is when I went to re-install PFsense I decided to see about installing a newer ver.

Offline sullrich

  • Hero Member
  • *****
  • Posts: 5110
  • Karma: +7/-2348
    • View Profile
    • pfSense
Re: Installer doesn't see drives
« Reply #1 on: November 29, 2005, 11:40:45 pm »


Fixed in 0.95.c