Netgate SG-1000 microFirewall

Author Topic: "BTX halted" error with 2.2.2  (Read 4345 times)

0 Members and 1 Guest are viewing this topic.

Offline Benjanyan

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: "BTX halted" error with 2.2.2
« Reply #15 on: November 17, 2015, 04:59:29 pm »
pfSense 2.3-ALPHA would be worth a try. That is based on FreeBSD 10.2-STABLE. And also the build of pfSense 2.3-ALPHA is a lot more stock FreeBSD. So maybe among all those changes, something of FreeBSD that works for this hardware will now be in the pfSense build also.

(And worth checking that FreeBSD 10.2 is also still working fine on this hardware)

Good shout, Phil. I put pfSense-2.3-ALPHA-4g-amd64-nanobsd-vga-20151116-1309 onto a spare flash drive and it booted without issue on the first go. :)

Offline phil.davis

  • Hero Member
  • *****
  • Posts: 4618
  • Karma: +552/-3
    • View Profile
    • International Nepal Fellowship
Re: "BTX halted" error with 2.2.2
« Reply #16 on: November 17, 2015, 08:15:08 pm »
Quote
Good shout, Phil.
Just dumb luck. I had a particular Jetway board (very different hardware to this thread) that worked with 2.1.* but not 2.2.*, I should dig that out again and try it with 2.3.
As the Greek philosopher Isosceles used to say, "There are 3 sides to every triangle."
If I helped you, then help someone else - buy someone a gift from the INF catalog http://secure.inf.org/gifts/usd/

Offline FlashBack0

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
  • TheQuestForIdentity
    • View Profile
Re: "BTX halted" error with 2.2.2
« Reply #17 on: December 31, 2017, 06:12:09 pm »
 in overall for this problem to be salved, is to put the harddrive in to another laptop an install the OP, and then switch back the harddrive to the previous laptop to configuer the OP.