pfSense Forum

pfSense English Support => SNMP => Topic started by: alex_london on November 01, 2017, 08:53:39 pm

Title: SNMP reporting incorrect (double?) the bandwidth usage
Post by: alex_london on November 01, 2017, 08:53:39 pm
Hi,

I've just set up a new SG-3100, and using SNMP sensors in PRTG to monitor various statistics, including bandwidth. The reported bandwidth in PRTG seems to be double the actual use - I'm seeing 20Mbps where it should be closer to 10Mbps (I wish it was 20!).

I'm using a Multi-WAN setup, with policy-based routing, so I'm not doing anything fancy with load balancing etc. Both WAN links (WAN/mvneta2 and OPT1/mvneta0) seem to be exhibiting the same behaviour.

The RRD charts in the device itself seem to be correct.

Any thoughts?

Thanks,
-Alex
Title: Re: SNMP reporting incorrect (double?) the bandwidth usage
Post by: loos on November 02, 2017, 09:54:51 pm
This issue was found after the release of 2.4.1 and it is already fixed for the 2.4.2.
Title: Re: SNMP reporting incorrect (double?) the bandwidth usage
Post by: alex_london on November 03, 2017, 05:40:35 am
Ah, ok thanks! I'll await the update then...

-Alex