Netgate SG-1000 microFirewall

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 6lord6paragon6

Pages: [1]
1
I have the same issue.

Checked the status of the gateway, and that is marked as active.
NAT is set to automatic mode to carry the connection from LAN to WAN, but still there is no internet connection to my virtualbox hosts.

2
Hardware / Re: Initial login not loading the wizard
« on: June 19, 2014, 07:11:03 am »
Never mind, I tested with a different OS.

It is only with Windows server 2012 and 2007 that this issue had occurred.
Windows 8.1 successfully logged in and loaded the wizard.

For curiosity's sake, anyone know why windows server does this?

3
Hardware / Re: Initial login not loading the wizard
« on: June 18, 2014, 08:30:40 am »
Oh, right, it's version 2.1.3.

4
Hardware / Re: Initial login not loading the wizard
« on: June 18, 2014, 08:29:53 am »
Normal install type, just went with the quick and easy install, did no strange configurations on pfSense.
Wan IP address was assigned by the dhcp server on my router, lan address is 192.168.200.50, which it connects to, I log in successfully, and then I receive that screen.
The wizard does not come up, and I don't have an option to bypass the setup wizard.

5
Hardware / Re: Initial login not loading the wizard
« on: June 18, 2014, 08:15:45 am »
It's the latest version I could download, and it's running on virtualbox.

It worked initially, but stopped.
I've completely deleted it and installed it again.
Trying to log in from Windows server 2012 and 2010, both giving the same issue.
I have not yet tried it from a different OS.

6
Hardware / Initial login not loading the wizard
« on: June 18, 2014, 02:02:15 am »
Good day.

Please refer me if there is already a thread open for this, but I get the below screen, and it just stays there.
There's no link linked to the logo as the message mentions, so I can't configure pfsense at all.

Welcome to pfSense!

One moment while we start the initial setup wizard.

Embedded platform users: Please be patient, the wizard takes a little longer to run than the normal GUI.

To bypass the wizard, click on the pfSense logo on the initial page.

Pages: [1]