Netgate SG-1000 microFirewall

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Towawi

Pages: [1]
Hardware / Re: SMART Error: Unknown USB bridge
« on: March 06, 2018, 05:31:32 pm »
USB flash disks rarely have useful smart data, just ignore it.
Is that a fact? Or simply your opinion? Sweeping statements like that can be dangerous for people that don't know any better.

Hardware / Re: SMART Error: Unknown USB bridge
« on: March 06, 2018, 05:28:51 pm »

You have to specify the type of device you are using. If -d test doesn't work, try some values  but my SanDisk is found with "-d scsi".

Code: [Select]
smartctl -a -d scsi /dev/da0
Do you have the same USB disk as me?

General Questions / Re: pfSense with only ONE ethernet port?
« on: June 18, 2016, 05:20:31 am »
Thanks. Do you know where I can find more information on the subject?

General Questions / pfSense with only ONE ethernet port?
« on: June 17, 2016, 11:41:53 pm »
Can pfSense be installed and configured using only one ethernet port?

Hardware / SMART Error: Unknown USB bridge
« on: December 12, 2015, 02:41:31 am »

I've recently installed pfSense onto a new usb drive and everything appears to be working fine. However, Ive noticed the SMART status is now "Unknown" and upon running any SMART tests I receive the following error...

smartctl 6.4 2015-06-04 r4109 [FreeBSD 10.1-RELEASE-p24 amd64] (local build)
Copyright (C) 2002-15, Bruce Allen, Christian Franke,

/dev/da0: Unknown USB bridge [0x0781:0x5583 (0x100)]
Please specify device type with the -d option.

Use smartctl -h to get a usage summary

The USB drive in question is a "SanDisk 16GB Cruzer Ultra Fit" (USB 3.0)

I can only assume this usb device is currently unsupported as its a new product from SanDisk. If that's the case would it be silly to wait and see if the next pfSense update supports this device?

General Questions / Re: ADSL bridge/PPPoE Question...
« on: September 03, 2015, 11:46:32 pm »

Heres another way...

Thank you that is good to know. However, it doesn't answer my paranoid question above...

General Questions / ADSL bridge/PPPoE Question...
« on: September 03, 2015, 11:25:02 pm »
Is it any less secure plugging an ADSL modem (running in bridge mode) into a switch before connecting it to the WAN port of a pfSense box?

For years I've had my ADSL modem plugged directly into the WAN port of my pfSense box. From there the LAN port would go straight to my switch, which then provides my network with internet connectivity. The only problem with this is, I've never been able to connect to my modem because I assume its "on the other side of the router"...

Recently I discovered I can connect my bridged modem to a switch first, then plug it into both the LAN and WAN port on my pfSense box, and still get the same outcome. Except now I can also connect to my modem too.

Initially I thought this might make my network "open to the internet" but upon thinking about it more I dont think it does.


Pages: [1]