Netgate SG-1000 microFirewall

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Sixplustwoiseight

Pages: [1]
General Questions / Re: Can't access PFsense or the Net
« on: March 11, 2018, 03:47:26 pm »
Looked at the diagram more closely and this is impossible as pfsense is on the same subnet as the laptop.  Bad mask(s) or the Switch is hooked up/configured wrong.

the answer was here

the device is kinda defective as shown

Int 1 ---> ibg0
Int 2 ---> ibg2
Int 3 ---> ibg3
Int 4 ---> ibg1

this is the port config of the device..this is why it didnt work because it wasnt the correct port.

General Questions / Can't access PFsense or the Net
« on: March 07, 2018, 08:40:27 pm »
Sorry if this isn't the right place for this post..first timer here!

here is my current set up

From the laptop i can ping the laptops IP, Netgears IP and for PFsense it says <ip> : destination host unreachable

From Pfsense console i can ping && but i cant ping the laptop or the netgear..

I'm currently out of ideas why this is happening i've also tried different laptops with different OS's and different cat6 cables..still no luck...

i also moved the switch between vz and pfs still no luck..

i also tried to connect to pfsense directly with the laptop under the same subnet with and without gateway..still no luck

Pages: [1]