Netgate Store

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - faldfjie

Pages: [1]
1
General Questions / PPPoE
« on: February 07, 2018, 11:39:28 pm »
Hi, I have been trying to get my PPPoE connection working for a couple hours (2.4.2) and am having no luck with it.  The configuration I have seems like it should work, but it isn't.

I am trying to connect to Century Links gig e service.  It comes encapsulated in VLAN 201.

What I did was install pfsense and went through the getting started wizard.

I configured the WAN port to PPPoe, and put in my username/password.

I then went to the Interface assignments page and created a VLAN ID 201 and assigned it to the WAN interface.  Under the PPP setting, I bound it to the physical interface connected to century link.

I also set the Dial on Demand and Time Outs per https://kdemaria.wordpress.com/2015/04/22/how-to-configure-pfsense-2-2-2-for-centurylink-gigabit-seattle-edition/

When I look at the PPP logs I get:

Feb 7 19:43:24   ppp                        [wan_link0] Link: reconnection attempt 65

Feb 7 19:43:24   ppp                        [wan_link0] PPPoE: can't connect "[14]:"->"mpd67494-0" and "[261]:"->"left": No such file or directory

Feb 7 19:43:24   ppp                        [wan_link0] can't remove hook mpd67494-0 from node "[14]:": No such file or directory

Feb 7 19:43:24   ppp                        [wan_link0] Link: DOWN event
Feb 7 19:43:24   ppp                        [wan_link0] LCP: Down event

I am wondering if I am overlooking something obvious.  It just seemed to me like you setup the WAN link for PPPoE go to Interface-->Assignment-->VLAN and create a tag you associate with the physical adapter the WAN connection is using and you should be cooking with gas.

Anyone have a clue?

Pages: [1]