Netgate Store

Author Topic: IPv6 not up after update  (Read 1559 times)

0 Members and 1 Guest are viewing this topic.

Offline hda

  • Hero Member
  • *****
  • Posts: 601
  • Karma: +32/-4
    • View Profile
IPv6 not up after update
« on: May 02, 2016, 06:27:51 pm »
Auto system reboot after upgrade to Latest Base System 2.3.1.a.20160502.0743 did again not start up IPv6. It shows on igb1 (LAN), while normally is on igb0 (WAN). I found XID mismatch, so then found & killed 2 PID's. Disconnected PPPoE & Connect did not help. Next another manual reboot makes it all OK with IPv6 on igb0 as is usual.
« Last Edit: May 08, 2016, 06:22:13 am by hda »

Offline hda

  • Hero Member
  • *****
  • Posts: 601
  • Karma: +32/-4
    • View Profile
Re: IPv6 not up after update
« Reply #1 on: May 08, 2016, 06:05:30 am »
Still this same phenomenon with Latest Base System 2.3.1.a.20160508.0101.

Due to 2 PID's of dhcp6c [Why?], WAN(igb0) cannot succeed, and/then LAN(igb1) is appointed but not effective.
To get rid of the ISP-IPv6 over igb1, a reboot is necessary.

This time I saw PPPoE(IPv4) was not established. So, is it eventually necessary that IPv6 should wait for IPv4 to finish successfully?
« Last Edit: May 08, 2016, 06:22:26 am by hda »