Netgate SG-1000 microFirewall

Author Topic: 802.1p/q pfsense setup  (Read 21588 times)

0 Members and 1 Guest are viewing this topic.

Offline TourniquetRules

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
Re: 802.1p/q pfsense setup
« Reply #75 on: May 23, 2016, 08:46:36 pm »
I followed the guide by ITNUTT, flyovercountry and atlantisman.  I am using their recommended Netgear switch and pfsense on a super micro configuration found elsewhere on this board. The internet works fine with speeds of 914/930.  The TV channels all come in but all freeze after a couple of minutes.  Changing channels gets it going again.  I have 3 TV boxes.  I worked with Google support for an hour today trying to narrow it down.  Ultimately I hooked the Google network box back up and the TV worked fine.  The closest we could come was bad setup on my end which they don't support or poor signal to the boxes (which may be true however it does work with the existing Google network box). If anyone has similar experience or solutions please post.

Offline rsaanon

  • Jr. Member
  • **
  • Posts: 26
  • Karma: +0/-0
    • View Profile
Re: 802.1p/q pfsense setup
« Reply #76 on: October 26, 2016, 07:43:34 am »
Hi folks,

Wondering if anyone is using Cisco SMB switch for the QoS setup for the Google fiber.  If so, it would be much appreciated if the setup/configuration can be shared.