pfSense English Support > Wireless

"Wireless Status" web page?

(1/1)

dracunciliasis:
Hello

In the webpage of "Wireless Status" I can obly figure out what RSSI means can anyone tell me what do the other field mean??

Dracunciliasis

hoba:
lsf explained some of this already: http://forum.pfsense.org/index.php?topic=866.msg5201#msg5201

dracunciliasis:

--- Quote from: hoba on June 04, 2006, 02:24:44 pm ---lsf explained some of this already: http://forum.pfsense.org/index.php?topic=866.msg5201#msg5201

--- End quote ---

Tnakyou for your help but in the link you presented only the CAPS (capabilities) is described, there's no information about: AID, TXSEQ, RXSEQ and ERP

lsf:
CAPS = Capabilities

Depending on the capabilities of the APs, the following flags can be included in the output:

E - Extended Service Set (ESS). Indicates that the station is part of an infrastructure network (in contrast to an IBSS/ad-hoc network).

I - IBSS/ad-hoc network. Indicates that the station is part of an ad-hoc network (in contrast to an ESS network).

P - Privacy. Data confidentiality is required for all data frames exchanged within the BSS. This means that this BSS requires the station to use cryptographic means such as WEP, TKIP or AES-CCMP to encrypt/decrypt data frames being exchanged with others.

S - Short Preamble. Indicates that the network is using short preambles (defined in 802.11b High Rate/DSSS PHY, short pre- amble utilizes a 56 bit sync field in contrast to a 128 bit field used in long preamble mode).

s - Short slot time. Indicates that the network is using a short slot time.

---------------------------------------------------------------------

AID = Association ID (describes the ID that the AP has given to a certain mac/client)
IDLE = idletime
TXSEQ = Transmit Sequence
RXSEQ = Receive Sequence
ERP set to 0 means the device is 802.11 compliant. For more info about ERP read up on the 802.11 standard.
RSSI = Receive Signal Strength Indicator

RSSI to dBm can be calculated like this for Atheros cards:

RSSI_Max = 60
Convert % to RSSI
Subtract 95 from RSSI to derive dBm
Notice that this gives a dBm range of 35dBm at 100% and 95dBm at 0%.

PS. RSSI is different for most vendors. and can not be campared easily (ex. Cisco has 0 -->100 ). Also it is not a very acurate means to measure signal quality, rather it measures strengt only.

Navigation

[0] Message Index

Go to full version