I took latest update today and now I have a dead switch
General initialization - Version: 1.0.0
AVS selection from EFUSE disabled (Skip reading EFUSE values)
Overriding default AVS value to: 0x23
Detected Device ID 6820
High speed PHY - Version: 2.0
Init Customer board board SerDes lanes topology details:
| Lane # | Speed| Type |
------------------------------|
| 0 | 3 | SATA0 |
| 1 | 5 | PCIe0 |
| 2 | 3 | SATA1 |
| 3 | 4 | SGMII2 |
| 4 | 5 | PCIe1 |
| 5 | 5 | USB3 HOST1 |
PCIe Ref. Clock Buffer Control is 0xf00015bf, setting to 0xf00015bf
SOC_CONTROL_REG1 is 0xf00015bf, setting to 0x0707c0f3
PCIe, Idx 0: detected no link
PCIe, Idx 1: detected no link
High speed PHY - Ended Successfully
mv_ddr: mv_ddr-armada-17.06.1-g07f8294 (Oct 8 2018 - 12:59:22)
DDR4 Training Sequence - Switching XBAR Window to FastPath Window
mv_ddr: completed successfully
| / | __ _ _ ____ | | |
| |/| |/ _` | '\ \ / / _ \ | |
| | | | (| | | \ V / __/ | |
|| ||_,|| _/ _|||
_ _ ____ _
| | | | | __ ) ___ ___ | |
| | | || _ \ / _ \ / _ | __|
| || || |) | () | () | |_
_/ |____/ _/ ___/ __|
** LOADER **
U-Boot 2013.01-02879-geb5cbf6642 (Oct 08 2018 - 12:59:19) Marvell version: devel-17.06.0
Board: Rogue-1
SoC: MV88F6820 Rev A0
running 2 CPUs
CPU: ARM Cortex A9 MPCore (Rev 1) LE
CPU 0
CPU @ 1600 [MHz]
L2 @ 800 [MHz]
TClock @ 250 [MHz]
DDR4 @ 800 [MHz]
DDR4 32 Bit Width,FastPath Memory Access, DLB Enabled, ECC Disabled
DRAM: 2 GiB
MMC: mv_sdh: 0
DBG: Calling spi_flash_probe from env_relocate_spec()
SF: Probing bus 0 cs 0 @ 20000000Hz mode 3
SF: Detected W25Q32JV with page size 4 KiB, total 4 MiB
PCI-e 0: Detected No Link.
PCI-e 1: Detected No Link.
USB2.0 0: Host Mode
USB3.0 1: Host Mode
Map: Code: 0x7fedc000:0x7ff9741c
BSS: 0x7ffef600
Stack: 0x7f4cbf20
Heap: 0x7f4cc000:0x7fedc000
U-Boot Environment: 0x00100000:0x00110000 (SPI)
Board configuration detected:
Net:
port
Interface
PHY address
egiga0
RGMII
0x00
egiga1
RGMII
0x01
egiga2
SGMII
In-Band
egiga0 [PRIME], egiga1, egiga2
Hit any key to stop autoboot: 0
reading ubldr.bin
** Unable to read file ubldr.bin **
Starting application at 0x00200000 ...