pfSense Support Subscription

Author Topic: advice to upgrade from USB memstick 2.2.1 to 2.3.5 on HDD  (Read 185 times)

0 Members and 1 Guest are viewing this topic.

Offline AMizil

  • Jr. Member
  • **
  • Posts: 28
  • Karma: +1/-0
    • View Profile
advice to upgrade from USB memstick 2.2.1 to 2.3.5 on HDD
« on: November 04, 2017, 12:17:51 pm »
Hello,

I have a pfSense box running on Atom D2500CC installed on a USB memstick 2 GB with 1 GB RAM - version 2.2.1 - x86 version.
I Would like to put a HDD inside the firewall and do a fresh install of pfSense 2.3.5 CE x86 and  restore the configuration from 2.2.1 x86.

Is this upgrade recommended ?

Thanks,
Adrian

Offline haleakalas

  • Full Member
  • ***
  • Posts: 108
  • Karma: +8/-2
    • View Profile
Re: advice to upgrade from USB memstick 2.2.1 to 2.3.5 on HDD
« Reply #1 on: November 05, 2017, 07:33:33 am »
You can do it 2 ways:
- You can backup your configuration through webconfigurator while your USB flash is running, then install your bare hard drive and do a clean install of 2.3.5, start it up, then restore your backed up configuration
- Or, you can image copy the content of your flash usb onto your hard disk drive (using dd or similar software), then install it in your machine, boot from it and then when 2.2.1 is up and running perform a system upgrade.
Upgrading to 2.3.5 is a good move as quite a few security updates have been applied to pfsense post 2.2.1.
« Last Edit: November 05, 2017, 07:59:12 am by haleakalas »

Offline AMizil

  • Jr. Member
  • **
  • Posts: 28
  • Karma: +1/-0
    • View Profile
Re: advice to upgrade from USB memstick 2.2.1 to 2.3.5 on HDD
« Reply #2 on: November 09, 2017, 03:14:21 pm »
You can do it 2 ways:
- You can backup your configuration through webconfigurator while your USB flash is running, then install your bare hard drive and do a clean install of 2.3.5, start it up, then restore your backed up configuration

I get regular backups of the configurations each time I change something . I wasn't sure if config from 2.2.4 is compatible with 2.3.5
I have ordered a new SSD and I will do a clean install  , then restore the configuration.

I did this trick once in the past , but I had a backup from a 32bit config and I have installed 64bit version of pfSense and only  RRD graphs were lost.

Thank you,
Adrian

BlueKobold

  • Guest
Re: advice to upgrade from USB memstick 2.2.1 to 2.3.5 on HDD
« Reply #3 on: November 10, 2017, 10:47:32 am »
pfSense 2.4.0-RELEASE Now Available!
You will need 5 minutes to read all, but it is worth the time, you will be sorted with any information you really need!