Router NG-1100
Setup 1:
Connected to LAN-port (call it LAN1):
Local network 172.0.0.0. The connection is to a managed switch which is having DHCP-service running
Connected to OPT-port (call it LAN2):
Local network 10.0.0.0. The connection is to a managed switch which is having DHCP-service running.
Connected to WAN-port (call it LAN3):
New Local network assigned by the NG-1100. Could be network 192.168.99.0.
Any device, but usually my laptop, running Debian Linux. If I connect a switch to this port, multiple devices should be able to connect and get its address from a DHCP-server.
So in this setup I would like any device connected to LAN3 to get a 192.168.99.0 address from DHCP.
The device connected on LAN3 must be able to communicate with all devices on LAN1 and LAN2
The devices on LAN1 and LAN2 should not be able to communicate with each other
Setup 2:
LAN-port and OPT-port same as above
WAN-port: Connected to a Nighthawk M1, or similar LTE+WiFi router
In this setup same rules apply as above, but I wan't all devices connected to M1 to be able to communicate to LAN1 and LAN2
Are these setups possible with the NG-1100?
Any suggestions and pointers on how to accomplish this in Pfsense
Thanks!